Line-A-Duct

Ductformer Line-A-Duct DL-60 (or 72)

Ductformer Line-A-Duct DL-60 (or 72) is designed to be installed in any manufacturer’s Duct Coil Line System. The glue is first applied to the metal then the liner is cut to the exact length and pressed on to the part. A Weld Pin System (not pictured) installed after the DL-60 (or 72) would pin the liner to the metal after insulation has been applied.

Coil Line InsulatorLine-A-Duct Brochure
Click Here
U.S.A. FlagMade in the U.S.A. Process 48,60,72” coil widths
1/2” to 2” liner
TDC Slip and Drive and Raw edge
Extrudes glue adhesive
Cuts insulation material to length
Load 2 rolls of insulation
Features

  • Glue extrusion system eliminates overspray and minimizes maintenance
  • 2 Insulation rolls mounting
  • Variable speed drives allow operator to fine tune
  • Common readily available and affordable “off the shelf parts” such as shear blade and pneumatic cylinders
  • Installs easily in any manufacturers coil line, perfect for add on or replacement of older systems
  • Plug into standard power and air (no special electrical shop rewiring costs compared to press brake set-up)
 Specifications

  • Material Range……………….1/2 –2” Liner
  • Material Widths………………..44”-60”-72”
  • Length……………………………………142”
  • Working Height……………………..32”-40”
  • Width…………..(5 ft model)……………72”
  • Air…………………………….PSI 120 CFM 3
  • Voltage………………………110 & 220/440
  • Electrical……………….3 Phase / 50/60Hz

Leave a Reply

Your email address will not be published. Required fields are marked *

fifteen − 4 =